In this first lesson, you will go through the process of unboxing your computer on module and carrier board and assembling the hardware.
A block diagram of the system setup and its connections is presented below for reference.
System setup block diagram
| List of required items |
|---|
| HDMI display/monitor |
| Accessory kit : |
| - 12V 30W power supply |
| - USB type C to type A cable |
| - Ethernet cable |
| - USB keyboard and mouse |
| List of recommended items |
|---|
| Verdin heatsink (product coming soon) |
A headless setup is possible, though in the Quickstart Guide we will always assume that you have a recommended display attached to the carrier board. If you proceed without a display, skip the lessons that make use of it at your own discretion. As an option, you can follow the Torizon Documentation - just be aware you will not find a walkthrough as thorough as this guide.
Note: Carefully read this module's cover page clicking on "Module 1: Unboxing and Bring-up" on the left menu bar before starting this lesson.
Remove the Dahlia Carrier Board and the Verdin Computer on Module from the blisters. Insert the computer on module into the X1 connector of the carrier board as tight as possible, with the module inclined ~30 to 45 degrees in relation to the carrier board.
Connecting the computer on module to the Dahlia Carrier Board
Warning: Make sure that the module is well connected to the carrier board. The image below has some checkpoints highlighted.
Computer on Module connected to the Dahlia Carrier Board
Connect the DSI to HDMI adapter to the X17 connector of the carrier board. Fixate it by screwing the four included screws.
Connecting the DSI to HDMI adapter to the Dahlia Carrier Board
Note: Ethernet network must provide DHCP and Internet to the module.
Attention: Double check that your power supply is within the Dahlia Carrier Board limits (7-27V) and that the polarity is not inverted. Also, make sure that the current capability of the power supply is enough, or the system may shut down unexpectedly. For evaluation purposes, a 12V 2A power supply is recommended.
HDMI, Ethernet, USB keyboard and power supply connected to the Verdin Development Board
Screw the Verdin Industrial Heatsink on top of the SoM, using the screws that come with it:
Dahlia With the Verdin Industrial Heatsink
